11
Horizontal Sanding Workstop
1. Loosen the socket head cap screw (A, Fig. 7)
so that the sanding belt can be rotated to the
horizontal position.
2. Rotate the sander until the stop (B, Fig. 7)
contacts the sander base. Tighten the socket
head cap screw.
3. When the sanding belt is used in the horizontal
position, the table may be used as a workstop,
as shown in Figure 7.
Sanding Belt Replacement
1. Disconnect the machine from the power
source.
2. Remove the handle (A, Fig. 8).
3. Release two latches (B, Fig. 8) and open the
doors.
4. Pivot the trunnion assembly (A, Fig. 9) out of
the way.
5. Release the belt tension by moving the tension
handle to the “Loosen” position.
6. Slide the belt off of both sanding drums.
7. Slide new 6”x48” sanding belt over both
sanding drums, making sure the belt will travel
in the direction of the arrow located on the
inside of the belt.
8. Re-apply belt tension by moving the tension
handle to the “Tighten” position. See “Belt
Tracking Adjustment”.
Figure 7
Figure 8
Figure 9