Extension table
Attach the planer outfeed extension table (J) to the main
planer table (F4) with three socket head cap screws (AA)
and flat washers (HH). Tighten screws with 5mm hex
wrench.
Extension table adjustment
Two setscrews located underneath the extension table (J)
are used to adjust the height position of the outer
(protruding) edge, which must be slightly higher than the
main planer table (F4) in order to minimize snipe.
Using a 4mm hex wrench (provided), turn setscrews slightly
clockwise to raise the table.
Thickness table lock handle
Fig 6
Attach thickness table lock handle (U) and flat washer (T).
Cutter head guard
Fig 7
Install cutter head guard (D) to the side of the jointer outfeed
table.
5.3 Mains connection
Mains connection and any extension cords used must
comply with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a 16 A surge-proof fuse.
Only use connection cables marked H05VV-F
Connections and repairs to the electrical equipment may
only be carried out by qualified electricians.
5.4 Dust connection
Before initial operation, the machine must be connected to a
dust extractor.
5.5 Starting operation
You can start and stop the machine with the ON/OFF-button
(H, Fig7).
In case of machine overload the motor overload cut-off (G)
will react.
After appr.5 min of cooling the overload cut off can be reset.
6. Machine operation
6.1 Jointing and planing
Disconnect machine from power source before making any
adjustments. Failure to comply may cause serious injury.
Fig 8
Loosen lock handle (U).
Install planer table height adjustment handle (S).
Turn handle (S) counter-clockwise and lower planer table
(F1) all the way.
Remove hex nut (B1) and flat washer (B2) from dust chute
(B).
Orient the dust chute (B) as shown and install into the infeed
opening.
Position the chute (B) such that the 2 positioning pins and
the positioning screw meshes with the positioning holes on
the table (F1).
Raise the table until the dust chute (B) is held firmly in place
between the planer infeed table (F1) and jointer outfeed
table (F2). Do not overtighten.
Tighten lock handle (U).
