Jet JJ-6HHBT, Operating Instructions And Parts Manual

Page: 9 / 24

9
If adjustment is needed, loosen hex nut, turn hex
head bolt to proper position and secure in place
with hex nut.
Figure 8-4
Figure 8-5
8.4 Mounting brackets
The jointer weighs approximately 72 lbs. when
completely assembled. The jointer must be
installed in a place with ample lighting and
correct power supply.
Make sure there is plenty of room for moving the
workpiece through the entire cut. There must be
enough room that neither operator nor
bystanders will have to stand in line with the
wood while using the tool.
Jointer can be installed on a workbench using
the provided mounting brackets (A, Figure 8-6).
Secure with bolts, lock washers and hex nuts
(not supplied).
The jointer must be bolted to a firm, level
surface. Make sure the jointer does not rock and
the tables are level.
Figure 8-6
9.0 Operating controls
Disconnect machine from
power source before making any
adjustments. Failure to comply may cause
serious injury.
Refer to Figure 9-1.
The operating positions of the On-Off switch are
located on the front of your jointer.
Push the switch up to turn jointer on and push
down to turn the unit off.
The switch has a removable key that allows the
unit to be locked in the OFF position.
To activate locking mechanism:
Push the switch (A) to OFF position.
Pull switch key (B).
To deactivate locking mechanism:
Insert and press switch key in the slot on switch.
Figure 9-1