Jet JBTS-10BT-3, Operator'S Manual

Page: 36 / 44

8
Back Rail Installation
1. Locate the back rail which is 2" x 2" with holes
running along one side only. The height of the
back rail when attached to the saw is not
critical.
2. Align the holes in the back rail to the holes in
the table top, as shown in Figure 4.
3. Secure the back rail to the pre-tapped holes in
the saw table (B, C, Fig. 4) with two 5/16 x 3/4
hex cap screws and two 5/16 flat washers, as
shown in Figure 5. Tighten screws securely
with a 1/2" wrench.
4. Secure the back rail at A and D (in Figure 4) to
each extension wing with a 1/4 x 1-1/2 hex cap
screw, two 1/4” flat washers, a 1/4” lock
washer, and a 1/4” hex nut as shown in
Figure 6.
5. Tighten nuts.
Important: If you are installing an optional wood
extension table on your saw, it should be installed
first
before mounting the guide tube. This will
prevent having to mount and align the guide tube
twice.
If you are not mounting an optional wood table,
proceed to
Guide Tube section.
Figure 4
Figure 5
Figure 6