Jet HVBS-710SG, Operating Instructions And Parts Manual, Page: 8 / 32

8
7.0 Set-Up and Assembly
7.1 Unpacking and cleanup
Inspect contents of shipping container for
shipping damage. Report any damage to your
distributor.
Remove all contents from carton, and compare
to the contents list in this manual. Report any
part shortages to your distributor. Do not discard
carton or packing material until machine is
assembled and running satisfactorily.
Exposed metal areas have a rust preventative
applied. Remove this with a soft rag and solvent
or degreaser. Do not use cellulose-based
solvents such as paint thinner or lacquer thinner;
these will damage painted and plastic surfaces.
7.2 Shipping contents
If you do not see a part below, check the
machine; some parts may have come pre-
assembled to the saw.
Refer to Figures 2 and 3.
1 Band Saw
1 Workstop bar – A
1 Workstop – B
1 Workstop rod – C
1 Filter screen – D
1 Splash guard – E
1 Vertical cutting plate – F
1 Handle – G
1 Axle – H
2 Wheels –
I
2 Stand sides – J
2 Stand ends – K
1 Support post – L
1 Instructions and Parts Manual (not shown)
1 Warranty Card (not shown)
Hardware Package (p/n
HVBS710S-HP):
4 Hex cap screws 5/16
"
x3/4
"
– HP-1
2 Hex cap screws 1/4
"
x1/2
"
– HP-2
4 Lock washers 1/4
"
– HP-3
2 Flat washers 1/4
"
– HP-4
4 Hex cap screws 5/16
"
x1-1/2
"
– HP-5
8 Lock washers 5/16
"
– HP-6
12 Flat washers 5/16
"
– HP-7
4 Hex nuts 5/16
"
– HP-8
2 Cotter pins – HP-9
2 Flat washers 1/2
"
– HP-10
2 Hex cap screws 1/4"x5/8” – HP-11
Tools required for assembly:
12mm wrench
3, 4, and 6mm hex keys
Figure 2
Figure 3
Hardware package HVBS710S-HP