Jet HBS-56MVS, Operating Instructions And Parts Manual

Page: 7 / 32

7
5.0 Setup and assembly
Read and understand all
instructions before attempting assembly. Band
Saw must be disconnected from power during
all assembly procedures. Failure to comply may
cause serious injury.
Compare the contents of your container with the
following parts list to make sure all parts are intact.
Missing parts, if any, should be reported to your
distributor. Do not discard any packing materials
until saw is assembled and operating satisfactorily.
Read this instruction manual thoroughly for
assembly, maintenance and safety instructions.
5.1 Carton contents
0 1 Band saw (not shown)
0 1 Side plate - left (A)
0 1 Side plate - right (B)
0 1 Door (C)
0 1 Wheel base (D)
0 1 Plate - bottom (E)
0 2 Feet (F)
0 1 Front door knob (G)
0 2 Wheels (H)
0 1 Handle (J)
0 1 Work stop assembly (K)
0 1 Axle (L)
0 1 Chip pan (M)
0 1 Drip tray (N)
0 1 Open-end wrench 12/14mm (not shown)
0 1 Hex wrenches 3mm,4mm (not shown)
0 1 Owner's manual (not shown)
0 1 Product registration card (not shown)
1 Hardware package (p/n HBS56MVS-HP)
0 4 3/8" x 1-1/4" Hex Cap Screw (HP1)
12 5/16” x 3/4” Hex Cap Screw (HP2)
4 5/16” x 1-1/2” Hex Cap Screw (HP3)
33 5/16” Flat Washers (HP4)
4 10 x 23 x t2 Flat Washer (HP5)
0 4 5/8” x 30 x t3 Flat Washer (HP6)
0 2 3x25 Cotter Pin (HP7)
16 5/16” Hex Nut (HP8)
0 1 5/16” Nylon Nut (HP9), not shown
5.2 Tools required for assembly
Open-end wrench, 12/14mm (provided)
(Note: A ratchet wrench with sockets may
speed assembly time.)
Hex wrenches, 3mm,4mm (provided)
Cross point (Phillips) screwdriver
Figure 5-1: carton contents
Figure 5-2: hardware package HBS56MVS-HP
(Actual Size)