3
WARNING
1. This is a lifting device only. Do not move or dolly the vehicle while on the jack. The load shall be
supported immediately by other appropriate means.
2. Do not overload. Overloading can cause damage to or failure of the jack.
3. Lift only on areas of the vehicle specified by the vehicle manufacturer.
4. This jack is designed for use on hard, level surfaces capable of sustaining the load. Use on other
than hard, level surfaces can result in jack instability and possible loss of load.
5. Do not get under vehicle while jack is being used as the only support.
6. If jack appears damaged in any way, found to be badly worn, or operates abnormally, it shall be
removed from service. Contact your local JET distributor for the location of the nearest JET
Authorized Repair Station.
7. Use only genuine JET replacement parts if replacement of parts is necessary.
8. Failure to comply with these warnings may result in loss of load, damage to jack, and/or failure
resulting in personal injury or property damage.
Specifications: FLJ-45
Stock Number ...................................................................................................................................440445K
Scissors Capacity............................................................................................................................ 8,000 lbs.
Post Capacity ................................................................................................................................ 10,000 lbs.
Minimum-Maximum Scissors Height................................................................................... 2-9/16” to 16-7/8”
Minimum-Maximum Post Height ......................................................................................... 16-3/8” to 28-1/2”
Handle Length.................................................................................................................................... 35-1/2””
Overall Size (LxW/in) ............................................................................................................ 26-3/4” to 8-1/4”
Net Weight (approx.) .......................................................................................................................... 100 lbs.
Assembly
Note:
For parts identification, refer to parts breakdown located on page 5.
1. Insert one piece T-handle (25) into handle socket (34). Line up linkage (56) so that it fits into the
handle. Tighten socket head cap screw (29) to secure the handle.
2. Make sure handle engages the linkage (56) by turning handle knob (22).
3. Remove the screw (42) that is used for shipping. Replace the screw with the one that has an air
hole.
Lubrication
1. Linkage - use #2 tube grease where linkage (56) inserts into the handle.
2. Grease Fittings - inject #2 tube grease into two grease fittings (16).
3. Lubricate pivoting and moving parts with 30W oil.
Summary of Contents for FLJ-45
Page 5: ...5 FLJ 45 Parts Breakdown ...
