Jet Elite ECB-1422V, Operating Instructions And Parts Manual

Page: 17 / 36

17
ECB-1422V
14.6 MAINTENANCE SCHEDULE
If routine maintenance is neglected, the result will be premature wear and poor performance.
DAILY:
• General cleaning of machine; remove accumulated shavings.
• Clean coolant drain hole to avoid excess fl uid buildup in the trough.
• Top off the lubricating coolant.
• Check blade for wear.
• Raise saw head to top position and partially slacken the blade to avoid unneccesary yield stress.
• Check functioning of blade guards and E-stop button
WEEKLY:
• Thoroughly clean the machine to remove swarf, especially from the the coolant tank.
• Remove pump from its housing, clean the suction fi lter and suction zone.
• Clean fi lter of pump section head and suction area.
• Use brush to clean blade guides, especially the guide bearings. Clean drain hole over the coolant tank.
• Clean blade wheel housings and races.
MONTHLY:
• Check tightness of drive wheel screws.
• Check that blade guide bearings are in perfect running condition.
• Check tightness of screws for motor, pump, and blade guards
EVERY SIX MONTHS:
• Perform circuit continuity checks.
14.4 COOLANT
JET off ers a bio-degradable, concentrated fl ood coolant
(not provided) formulated for band saws, lathes, and
milling machines, with a 20:1 water/coolant mix ratio. See
JET website for more information and to order.
414124 JET Bio-Degradable Flood Coolant, 1/2 Gal.
414126 JET Bio-Degradable Flood Coolant, 1 Gal.
414127 JET Bio-Degradable Flood Coolant, 5 Gal. Pail
FILLING AND DRAINING
Pour coolant mixture into chip tray so that it drains through
strainer into basin. The sight glass is located on right side
of base.
To drain coolant use drain plug located on right side of
machine base. Follow local regulations when disposing of
used machine fl uids. Apply thread sealing tape to the drain
plug before re-installing.
Keep the overfl ow hole on right side of base, clean and
unobstructed.
Diff erent brands of coolant may not mix properly. If chang-
ing to new brand, fi rst fl ush coolant line and sump with
an industrial degreaser or cleaner that does not contain
silicone or petroleum based ingredients.
14.5 ADDITIONAL SERVICING
Any additional servicing should be done by qualifi ed
service personnel.