8
6.7 Adjustable handles
The handles (such as C, Fig.5) can be adjusted to more
convenient position; lift up handle and rotate it on the
pin, then release, making sure it reseats on pin.
7. Machine operation
Refer to Fig 9.
Fig. 9
A
–
Main on/off switch.
B
–
Direction switch: Controls belt direction,
center position is neutral (belt does not move). To
prevent build-up of chips and debris on the belt,
use appropriate belt direction for each operation:
Notching
–
Direction 1
Grinding side
–
Direction 2
Grinding top
–
Direction 2
C
–
On button: Starts belt movement.
D
–
Off button: Stops belt movement.
E
–
Emergency stop button: Press for fast shut-
down of machine functions. To restart machine,
rotate button clockwise until it disengages.
F
–
Hight / Lower Speed switch:
8. Maintenance and adjustment
Always disconnect power to
machine before performing maintenance. Failure
to do this may result in serious personal injury.
8.1 General maintenance
After each use, vacuum abrasive debris from machine
area. Wipe down machine with a clean rag and apply
light coat of oil to exposed metal surfaces to inhibit rust.
Keep notching table and guide shaft areas clean and
free of debris. Use a brush to clear shavings, not bare
hands.
8.2 Lubrication
Note: Roller bearings are sealed and do not require
further lubrication.
See Fig 10 and Fig 11.
1.Apply oil or grease to tension leadscrew and contact
points at hex nut.
2.Apply oil or grease to jaw leadscrew.
3.Apply grease to swivel base area.
4.Clean and apply oil to long and short guide shafts.
Fig.10
Fig. 11
