10
Cleaning the Filter
CAUTION
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
Clean both the filter and collector can frequently
to keep the collector's performance at its
optimum. To clean:
1.
Disconnect the machine from the power
source.
2.
Take off the grounding clip and remove the
filter (A, Fig. 5) by turning clockwise.
3.
Empty the contents into an appropriate
container.
4.
The filter can be cleaned with a low
pressure air hose. Blow from the outside of
the filter to clean the dust particles.
For
best results check and empty the filter
frequently. Some applications will fill up the
filter quicker than others.
WARNING
Static electricity will build up in the filter
during operation. The filter ground must be
attached to the machine ground, and to the
filter. Failure to comply may result in
fire/loss of property, or personal injury!
5.
Install the filter and reattach the grounding
clip.
Emptying the Collector Can
1.
Disconnect the machine from the power
source, unplug.
2.
Lift the dust collector off the collector can
(B, Fig. 5).
3.
Dispose of the contents in the collector can.
Use the proper type hose (C, Fig. 5) to connect
the
dust
collector
to
the
machine
being
operated. Dryer vent hose is not acceptable for
this
purpose.
Contact
your
nearest
JET
distributor for the full line of JET Dust Collector
Hoses
and
Accessories.
Customize
your
installation and obtain maximum performance
with JET's dust hoods, hoses, clamps, fittings,
and blast gates.
Order the Dust Collection Basics Video which
covers topics such as system design, duct
material, fittings, construction and grounding.
Stock # JW1050V
Summary of Contents for DC-650TS
Page 11: ...11 Parts Breakdown ...
Page 13: ...13 Wiring Diagram ...
