6
Read and understand the
entire contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
5.0
Setup and assembly
5.1
Unpacking
Remove all contents from shipping carton and
compare to the contents list in this manual. If
shipping damage or any part shortages are
identified, contact your distributor. Do not discard
shipping materials until dust collector is assembled
and running satisfactorily.
5.2
Shipping contents
Main carton
(see Figure 5-1)
1 Main unit – A
1
Flexible hose – B
1
Collection bag – C
2
4” Dia. Wire clamps – D
1
5” Dia. wire clamp – E
1
Dust funnel – F
4
Casters with fasteners – G
1
Wall mount plate – H
1
Upper support tube – I
1
Funnel support bracket – J
1
Locking lever – K
1
Inlet cap – L
1
Lower support tube – M
1
Inlet adaptor – N
Fasteners
(see Figure 5-2):
2
Carriage bolts M8x20 – HP1
2
Lock washers 8mm – HP2
3
Flat washers 8mm – HP3
2
Hex nuts M8 – HP4
2
Butterfly clamps – HP5
1 Hex cap lag screw – HP6
2
Phillips self-tapping screws – HP7
2
Screw anchors – HP8
2
Flat washers 8mm – HP9
2
Hex nylon lock nuts M8 – HP10
5.3
Tools required for assembly
13mm wrench
17mm wrench
Cross-point (Phillips) screwdriver
Drill with 1/4” and 5/16” bits (if mounting to wall)
Figure 5-1
Figure 5-2 (detail of fasteners)
