Jet DC-1100BK, Operating Instructions And Parts Manual

Page: 11 / 24

11
Filter Bag Kit Assembly
If you purchased a DC-1100BK, or DC-1100MK Dust
Collector, this section describes the assembly and
installation of the contents of the Filter Bag Kit (SN
708636F or 708636MF).
Filter Bag Installation
Referring to Figure 7:
1. Place the hanger (A) on the hanger bracket (B).
2. Slide the filter bag loop (C) over the hanger hook.
3. Feed the retainer strap (D) through the loops on
the filter bag (E) and fasten to the collector
housing (F).
Collector Bag Installation (30 Micron Kit)
Referring to Figure 8:
4. Insert the ring of the collector bag (A) at an angle
into the housing (B) through the opening at the
bottom. Pull down on the bag to make sure it
“seats” in the housing.
5. Position the plastic window in front so that you can
easily see when the collector bag is full.
Collector Bag Installation (5 Micron Kit)
The 5-Micron Filter Bag Kit includes clear plastic
collector bags. Refer to Figures 11 and 12 on the next
page, along with the accompanying instructions, to
install these.
After completing the filter bag and collector bag
installation, proceed to
Electrical Connections .
Figure 7
Figure 8