Jet BD-11G, Operating Manual, Page: 15 / 48

Place a warning sign on the machine.
WARNING!
Before reconnecting the machine, make sure that the change-
over switch on the lathe is in the "o" position
1.10.2 Using lifting equipment
WARNING!
Use of unstable lifting and suspension gear that might break under load can cause very
serious injuries or even death.
Check that the lifting and load suspension gear is of sufficient load capacity and in per- fect condition.
Observe the rules for preventing accidents issued by your association for the prevention of
occupational accidents and safety in the workplace or other inspection authorities.
Hold the loads properly.
Never walk under suspended loads!
1.10.3 Mechanical maintenance work
Remove all protection and safety devices before beginning maintenance work and re-install them once
the work has been completed. These include:
Ь Covers
Ь Safety indications and warning signs
Ь Earth (ground) connection
If you remove protection or safety devices, refit them immediately after completing the work. Check that
they are working properly!
1.11 Accident report
Inform your superiors and JPW (Tool) AG immediately in the event of accidents, possible sources of
danger and any actions which almost led to an accident (near misses).
These near misses can have many possible causes.
The sooner they are notified, the faster the causes can be eliminated.
1.12 Electrical system
Have the machine and/or the electric equipment checked regularly, and at least every six months.
Eliminate immediately all defects such as loose connections, defective wires etc.
A second person must be present during work on live components, to disconnect the power in the
event of an emergency. Disconnect the lathe immediately if there are any anomalies in the power
supply!
14