Troubleshooting
If after adjusting the infeed and outfeed tables, they are still too high for proper operation, the bracket may
not be “set.” Loosen slightly the flanged lock nuts (4) and firmly push down on the bracket. Re-tighten the
flanged lock nuts.
If the stock being sanded is bowed, warped or otherwise inconsistent, be sure tables are lower than the
conveyor surface.
If stock slips on conveyor belt, the tables may be positioned too high. Lower tables to allow stock to
remain in contact with the conveyor belt.
Parts List
Index Numbers refer to Figure 1.
Index No. Part No.
Description
Size
Qty
1 ............... 40-0330 ...................Table Bracket .............................................. ......................................... 2
2 ............... 10-9205 ...................Hex Cap Screw ........................................... 3/8-16x1” .......................... 4
3 ............... TS-0680041 .............Flat Washer ................................................. 3/8” ................................... 4
4 ............... 12-0209 ...................Flanged Lock Nut ........................................ 3/8”-16 .............................. 4
5 ............... 40-0331 ...................Extension Table ........................................... ......................................... 2
6 ............... 6714264...................Carriage Bolt ............................................... 1/4-20x3/4” ....................... 8
7 ............... 6861107...................Flat Washer ................................................. 1/4” ................................... 8
8 ............... 6514001...................Hex Nut ....................................................... 1/4”-20 .............................. 8