Jet-tech 737E, Technical Manual, Page: 16 / 18

16
MANUFACTURERS LIMITED WARRANTY
Jet Tech Systems Corporation (Jet Tech) hereby warrants all new warewashers
bearing the name JET TECH and installed within the continental United States of
America or Canada to be free from defects in material or workmanship, under normal
and regular usage and operation, for a period of one (1) year following the date
of original installation, (unless specified otherwise) but in no event can exceed
eighteen (18) months from the date of shipment from the factory.
If a defect in material(s) or workmanship is detected; or found to exist within
the stated period above, Jet Tech, at its sole discretion, shall either repair or
replace any original equipment manufacturers part which has proven to fail within
the machine; providing that the equipment has not been altered or tampered with in
any manner, has been installed correctly as per the owners manual, and maintained
and operated in complete accordance with this manual.
The labor cost to repair or replace any part proven to be defective, as per above
clause(s), shall be covered by Jet Tech Systems, within the continental United
States of America or Canada; provided that: prior authorization for this labor
was approved by Jet-Tech Systems, the service work was performed by an authorized
Jet Tech service agency; and that this agency installed an original and genuine
Jet Tech part in the machine. Any repair work performed by a non-authorized
service depot remains the sole responsibility of the user, and Jet Tech Systems
will not be held responsible. The installation of any generic part will not be
valid; and therefore voids this warranty. All authorized labor coverage shall be
limited to regular hourly rates only. Any supplemental hourly rates or charges,
such as weekends or emergency premiums remain the responsibility of the user.
Jet Tech Systems Corp. (Jet Tech) hereby states that: warranty travel time shall
be limited to, and without exception, a round-trip total of two (2) hours OR
mileage up to a maximum of one hundred (100) miles round-trip. Any charges
exceeding those stated herein must have prior authorization by the factory.
Exceptions to above warranty are: (A) Damages resulting from shipping, handling
or abuse. (B) Incorrect installation and/or connections. (C) Adjustments or
calibration of any parts. (D) Faults due to lack of regular maintenance or
cleaning of any internal part(s). (E) Replacement of any wearable items such as:
glasswasher curtains, or peristaltic squeeze tubing or gaskets. (F) Excessive
lime, mineral, alkali or hard water conditions and (G) Poor results due to: use of
an incorrect type of detergent (for non-commercial type applications), and
excessive or inadequate water temperature(s) or pressure conditions.
JET TECH SYSTEMS CORPORATION STATES THAT THERE ARE NO OTHER WARRANTIES, EXPRESSED
OR IMPLIED, THAT ARE NOT SET FORTH HEREIN, JET TECH SYSTEMS CORPORATION SHALL
ASSUME NO OTHER RESPONSIBILITY, EITHER DIRECT OR NON-DIRECT, OR BE LIABLE FOR ANY
OTHER OR ADDITIONAL LOSS OR DAMAGE WHETHER BEING DIRECT OR CONSEQUENTIAL, AS A
RESULT OF ITS EQUIPMENT.