4
4
INTRODUCTION
CONGRATULATIONS
on purchasing your new
Royal Jet-Pro Shower Spa
!
Before you begin installing your new shower spa, it is very important that you read through
all
of the docu-
mentation provided in this package and carefully follow the step-by-step installation instructions.
IMPORTANT NOTES & TECHNICAL SPECIFICATIONS
The manufacturer of the Jet-Pro Shower Spa strongly recommends that you employ a competent and
(if required by local code) licensed professional to install this product.
1. The
Jet-Pro Shower Spa
is designed for use with the existing on/off water pressure and temperature con-
trol valve already installed in your shower.
2. The
Jet-Pro Shower Spa
is designed for use in both your existing shower stall and/or your shower tub.
3. The
maximum
height for any existing or new construction wall mounted on/off water control valve in your
shower should be no more than 50 inches from the floor.
4. The recommended water pressure for the use of the
Jet-Pro Shower Spa
is 30psi to 80psi.
5. Estimated Assembly time: 1 hour.
PREPARATION
1. After opening the box (a) read all documentation carefully; (b) check for all parts listed in the
Parts List
to
make sure that everything has been included in the package.
2.
Examine the product for shipping damage. If the unit has been damaged, please contact the retailer you
purchased the product from within two (2) business days.
PLEASE NOTE: Jet-Pro Shower Spas
will
not
replace any damaged product or parts free of charge,
ONCE THE PRODUCT HAS BEEN IN-
STALLED.
3. Consult your local building or plumbing codes and/or consult a professional contractor or plumber for
questions or information regarding any installation compliance standards.
4. This installation process requires some drilling and basic plumbing knowledge. If you are not experienced
in these areas, Jet-Pro Showers Spas recommends that you use a competent, licensed contractor or
plumber for the installation of this product.
HELPFUL TOOLS NEEDED (but not included):
Tape Measure
Pencil for Marking Your Shower Wall
Cordless Electric Drill
1/4 inch Tile Drill Bit or Masonry Drill Bit
Channel Locks
Small, Adjustable Pipe Wrench
Box Cutters
Thread Seal Tape
Hack Saw
INSTALLATION INSTRUCTIONS FOR YOUR ROYAL MODEL JET-PRO SHOWER SPA
Please read the Introduction included with these instructions carefully to become familiar with all of the parts
of the
Jet-Pro Shower Spa unit
, the tools required and the installation process
. Be sure to follow these
step-by-step Installation Instructions in order to prevent any mistakes.
REMINDER: This Jet-Pro Shower Spa
is designed to be used with your existing on/off water pressure and
temperature control valve.
Before you begin, remove any shower products that may be inside your shower.
Make sure the area is free of any debris.
Place the spa in an area that will not be disturbed.
Organize all of the parts to prepare for installation.
INSTRUCTIONS FOR REMOVING OLD ESCUTCHEON COVER AND SHOWER ARM
1. Remove old shower head and shower head pipe from shower wall.
2. Turn shower arm counter-clockwise with adjustable wrench to disconnect shower arm from permanent
fitting inside wall.
Meijer.com