7
Reminder-Function:
Press the reminder-button , tp activate the function. The LED display shows
Two seconds later, the display starts to flash. Now press or to adjust the reminder time. The
default time of the reminder is 45 minutes, which is shown as
Then press any random button to save the time setup or wait for five seconds for the system to
automatically save the setup time. During the countdown, any operation results in a restart of the timer.
When the countdown finishes, the display shows
The reminder is a 10-second
„DiDi…DiDi…DiDi....“-tone
Within the 10-second reminder, you can press any random button to reactivate the countdown according to
the pre-selected default time. If no operation is executed during the 10-second reminder, there will be
another reminder after 5 minutes. If no operation is executed during the second 10-second reminder, the
Long-Time Sitting Reminder turs off automatically.
In order to manually turn of the reminder, press the button for three soconds. The display shows
Anti-collision sensitivity adjustment
– optional features:
Press the buttons and for five seconds to adjust the sensitivity. There are four levels: A-3, A-2, A-
1 and A-0, between which you can select using the arrow-buttons or .
If the display shows , the anti-collision function is off; if the display shows , low sensitivity is
selected. If the display shows , medium sensitivity is selected. If the display shows , high
sensitivity is selected (default-selection after purchase is A-3).
Should the tabletop touch any foreign object during height-adjustment, it immediately stops and reverses its
movement to avoid any possible damage.
Press the buttons
“▲” and “▼” for five seconds. If the display does not show any of the above-mentioned
symbols, there is no anti-collision function
Troubleshooting:
When the display shows or , press and hold the button
“▼” or , until the tabletop runs to the
lower or highest position, slightly reverses and stopps. The display now shows the height number. Release
the button
“▼”. The reset-process is now finished and you can go back to using the desk normally.
If an error-code shows in the display, press
“▼”, to return to or and start to reset
If you perform the above-stated steps and the desk still doesn
’t work properly, please contact the customer
service
