BA-40400-02-V14 | 29
Operating instructions
12 Menu configuration and main settings
12.1 Menu of TOPAX
In this chapter all of the TOPAX menus are presented and their operation
exemplified. As the display is in colour and high resolution, the menus
are shown in text and are clearly arranged.
12.1.1 Standard display
If there are no entries in the TOPAX within 5 minutes, the device turns
to the standard display.
mg/l
Disinfection
pH value
7.04
0.39
°C
temperature
26.3
DE
Topax DE
14:28 06.02.2012
Fig.18: Standard display of TOPAX
The bars below the digits of the measurements indicate the strength of
the respective output signal. The colour of the display changes, depends
on the signal power, from green (0-85 %) to orange (85 – 95 %) and
red (95 – 100 %).
Pressing any key takes you to the main menu (menu 1).
12.1.2 Menus 1 and 2: Main menu and sub-main menu
menu 2
trend
calibration
setpoint
ESC
status
mg/l
pH
°C
26.3
7.04
0.39
main menu
1
Fig.19: Menu 1: The TOPAX main menu and output point to reach all further
sub-menus and their functions. With the displays for
a
Disinfection,
b
pH
value and
c
temperature.
Menu 2 acts as a sub-main menu
a
b
c
alarms
controller
ESC
menu 2
recorder
night mode
service
2
mg/l
pH
°C
26.3
7.04
0.39
Fig.20: Menu 2: Extension of the main menu
12.1.3 Overview of the sub-menus
You can access all other sub-menus through the main menu (menu 1)
and the sub-main menu (menu 2).
Menu Key
Comment on sub-menu
1
Main menu
ESC
Return to the standard display
1.1
Target values Sets the setpoints of the configured controllers
1.2
Calibration
Calibration of all sensors connected to the system
1.3
Trend
Shows measurements as line chart in various
zoom stages
1.4.1
Status
Display of all important settings
2
Menu 2
Change to the following menus
2
Menu 2
ESC
Return to the main menu
2.1
Controller
Optimization of the parameters of all configured
controllers (access to this menu can be protected
by a password).
2.2
Alarms
Assigns the alarms to the measurement signals
23
Recorder
Sets the zooming function for the analogue outputs
0/4 … 20 mA
5
Service
Further adjustment options
(access to this menu can be protected by a
password):
• Configuration
• Inputs
• Auto setup (not
available)
• Network
• Time
• Password
• DIN contact (not
available)
• Alarm settings
• Recorder
• Display
• Hardware status (HW-
Status)
• Outputs
• Reset
• Logbook
• Timer (not available)
• Service password
• Flocking (not available)
• Start
• Digital inputs
• Language
On the following pages all sub-menus are presented in ascending order
and exemplified by means of a demonstrative example.
