Jensen QiCR-50, User Manual

Page: 10 / 14

E-9
SNOOZE FUNCTION
When the alarm sounds, tap the DIMMER/SNOOZE/SLEEP BUTTON (#5) to
temporarily turn off the alarm and activate the snooze function, the alarm will stop
and sound again 9 minutes later. If you tap the DIMMER/SNOOZE/SLEEP BUTTON
(#5) again, the alarm will temporarily turn off again and sound again in 9 minutes
and so on. The alarm sound will turn off after one hour.
NOTES :
•
To temporarily silence the alarm, press the DIMMER/SNOOZE/SLEEP BUTTON
(#5). The alarm will sound again when the snooze period (9 minutes) expires.
•
The corresponding Alarm 1 or Alarm 2 indicator (alarm or radio) flashes on the
display during the snooze period.
•
To cancel the snooze period and the alarm, press / MODE BUTTON (#8).
RADIO OPERATION
Listening to the radio
1. Tap the
/ MODE BUTTON (#8) repeatedly to Turn On the unit and select Radio
mode, frequency will show on the
LED DISPLAY (#16)
.
2. Press and hold the MIN / BUTTON (#4) OR HOUR / BUTTON (#3) to
search for the next / previous available station.
3. If the reception is poor, try Manual Tuning to fine-tune the station. Tap the MIN /
BUTTON (#4) OR HOUR / BUTTON (#3) briefly to manually tune through the
frequency band.
4. Adjust the
/ BUTTON
(#7) and
/ BUTTON
(#6) to obtain the desired
sound level.
5. When you have finished listening, press and hold / MODE BUTTON (#8) to
turn the radio off.
NOTES:
•
The LED DISPLAY (#16) will automatically switch back to showing the time after
a few seconds.
•
When listening to the radio, you can check the frequency of the station you are
listening to by tapping the MIN / BUTTON (#4) OR HOUR / BUTTON (#3).
The unit will automatically change back to the time after a few seconds.
Setting the Radio Station Presets
The unit allows you to store up to 10 s tations for easy recall at any time.
1. Press the / MODE BUTTON (#8) repeatedly to turn on the unit and select Radio
Mode.
2. Tune to the radio station you want to store in memory.
3. Press and hold the / MEM / M + BUTTON (#2). The preset channel number
“P01” will be flashing on the LED DISPLAY (#16) .
4. To change the preset channel number location, p ress the MIN / BUTTON (#4)
OR HOUR / BUTTON (#3) to step through the preset locations.
5. To confirm the preset location, press / MEM / M + BUTTON (#2).
6. To store another station presets, repeat steps 2-5 above.
RECALLING A PRESET STATION
In Radio mode, press the / MEM / M + BUTTON (#2) repeatedly to select the
preset channel.
TIPS FOR BEST RADIO RECEPTION
FM - If FM reception is weak, fully extend the wire antenna and vary the position and
location of the antenna until you find the strongest signal.