5
®
MCD 9424JA
✓
Testing
Before you finish the installation, you should do the following tests to make sure the wiring is correct
and everything is operating properly.
Test Antenna Connection
1. Press
or
. The
radio should tune to a
nearby station. If not,
check antenna con-
nection.
Test Memory Wiring
Test Power Wiring
1. Turn ignition switch on. The display should
light. If not, check the electrical connection
at the yellow and red wires.
Reconnect Battery
When wiring is complete,
reconnect the battery
negative terminal.
+
–
1. With the radio playing,
hold button 1 for five
seconds. The radio will
beep. You just stored the
current station in memory.
2. Turn the key off, then turn
the key on again.
4. Press button 1 again. It
should return to the station
that was playing before
(step 1). If not, make sure
the yellow wire is con-
nected properly.
3. Press
or
. The radio
will select a different
station.
2. Press
VOL
to increase
volume until you can
hear the radio playing.
Set the Clock
1. Press and hold DISP
button for 3 seconds
until display flashes.
2. Within 3 seconds, press
to change minutes,
to change hours.
2. Press PWR to turn the radio on. You will
see the radio display. If not, check electri-
cal connections to the red and yellow
wires.
VOL
1
2
W1
1
1
4
2
3
W1
1
5 Sec
DISP
1
2
0
1
2
3
M
H
3 Sec
3 Sec
5448-EIN.p65
7/23/99, 11:39 AM
5
