JXHDBT1
3
GETTING STARTED
Installing the Batteries
Locate the two 1.2V rechargeable AAA batteries included with your accessories and remove the
protective plastic shrink wrap. The battery compartment is located on the right side of your
headphones. Open the battery cover using a small cross head or flat end screw driver. Insert the
two 1.2V AAA rechargeable batteries, making sure the “+” and “-” poles are correctly positioned.
Replace the battery compartment cover and tighten gently.
CAUTION: Do not over tighten or apply too much pressure to the battery cover.
Battery Precautions
•
Keep batteries out of the reach of children.
•
Use only the supplied rechargeable 1.2V AAA batteries. Contact ASA Electronics for
replacement batteries.
•
While standard 1.5V AAA batteries may be used, do not attempt to recharge.
•
Turn the unit off before replacing batteries.
•
Observe correct polarity, as marked.
•
Please dispose of used batteries properly.
•
Do not use a leaking battery. If battery leakage occurs, avoid contact with skin. If contact
occurs, immediately wash thoroughly with soap and water. If battery leakage comes into
contact with your eyes, immediately flush with water and seek medical attention.
•
Do not expose batteries to excessive heat.
•
Do not overcharge the batteries. Charging the batteries for long durations of time may result
in reduced batttery life and damage.
Charging Your Headphones
When the battery power gets low, the LED indicator will emit a red light, along with a short beep
every minute. To recharge, connect the provided AC wall adapter USB cable to the port on the
JXHDBT1. The LED indicator will flash red and automatically disconnect paired devices. The
batteries will be fully charged after about 4 hours, or when the LED indicator shows a solid red
light.
Adjusting the Fit
Your JXHDBT1 headphones are fully adjustable for the most comfortable fit. To adjust, firmly hold
the top headband with one hand and the bottom headphone portion with the other. Do not hold by
the ear cups when adjusting the headband as damage could occur. Gently slide the two sections
up and down until you find the proper fit for you.
Passive Noise Reduction
Your JXHDBT1 Headphones use a Passive Noise Reducing design that reduces the ambient
noise around you for a more pleasurable listening experience. The noise reducing effect is
dependent on maintaining a good seal of the headphone cushions around the ears.
Summary of Contents for JXHDBT1
Page 1: ...JXHDBT1 Owner s Manual...
Page 11: ...JXHDBT1 9...
