E-6
RADIO OPERATION
1. Rotate the FUNCTION SELECTOR (#4) to select the desired band (AM or FM). The
dial scale LED will light up
2. Adjust the TUNING KNOB (#5) to tune in the station you want to listen to.
3. Adjust the POWER/VOLUME ON/OFF SWITCH (#2) to the desired volume level.
4. To turn off the Radio, rotate the POWER/VOLUME ON/OFF SWITCH (#2) fully
counter clockwise to the Off position.
Hints for best reception:
-
- AM : The receiver has a built-in AM bar antenna. If AM reception is weak, slightly
rotate or change the position of the unit will usually improve the AM reception.
- FM : The receiver has a build-in FM ANTENNA (#19) hanging at the rear cabinet.
This wire should be totally unraveled and extended for best reception.
PHONO OPERATION
Please Note - Before Use
-
Remove the stylus protector.
-
Be sure that the tone arm is unlocked and
free to move from the tone arm rest prior to
operating. Lock the tone arm in place again
when not in use.
1. Rotate the FUNCTION SELECTOR (#4) to select to the Phono position
2. Raise the turntable DUST COVER (#16).
3. Place a record on the TURNTABLE PLATTER (#8), use the 45 RPM ADAPTER (#9) if
required.
4. Set the SPEED SELECTOR (#13) to the proper position depending on the record to
be played.
5. Lift the tone arm from the rest by using the LIFT LEVER (#10)
and slowly move it over the record. The TURNTABLE
PLATTER (#8) will start to rotate.
6. Place the TONE ARM (#15) to the desired position of the
record.
7. Adjust the volume to the desired level.
8. At the end of record, the platter will automatically stop spinning.
Lift the tone arm from the record and return it to the rest.
9. To stop playing manually, lift the tone arm from the record and return it to the rest.
NOTES:
Certain types of records may have an auto-stop area outside the preset limit, so the
turntable may stop before the last track finishes. If this occurs, set the AUTO-STOP
SWITCH
(#12)
to the “OFF” position. This allows the record to play to the end, but please
note that it will not stop automatically. You must manually raise the tone arm and place it
back in the rest and then turn off the power to stop the turntable from spinning.
PITCH ADJUST
The PITCH ADJUST (#3) allows you to fine tune the playing speed of the record once
the correct speed (33/45/78 RPM) is chosen. Slide the Pitch Adjust Control to slightly
increase or decrease the speed of the turntable if necessary.
