9
To stop the music alarm immediately, tap the Power button.
SNOOZE FUNCTION
When the alarm sounds, it can be temporarily stopped by pressing the SNOOZE
button. The alarm sound will be suspended but the relative alarm indicator will keep
flashing.
The alarm will turn off for 9 minutes and then come again.
This manual snooze operation can be repeated again and again during alarm
sounding period.
LISTENING TO RADIO
Radio Tuning
1.
Tap the / FUNCTION
button
repeatedly to select AM or FM radio mode.
2.
To manually tune to a desired station, repeatedly tap the
/
buttons.
3.
To automatically search for stations with strong signals, press and hold either of
the
/
buttons until the frequency digits on display begins to scan then release
the button. The tuner will stop on the first strong station it finds.
4.
Press the Volume Up (+) and Volume Down (-) buttons to adjust the volume output
level.
5.
Tap the DISPLAY button to show the current station frequency on the display. The
station frequency will revert back to show the time automatically after about 5
seconds.
6.
Press and hold the / FUNCTION button to turn unit into standby mode after
listenning.
Notes:
-
Manual tune to select weaker stations that might be skipped during automatic tuning.
-
If the automatic tuning does not stop on the exact frequency of the station, for
example, it stops on 88.9 MHz instead of 88.8 MHz, use the manual tuning method to
"fine tune" to the exact frequency of the desired station.
HINTS FOR BEST RECEPTION:
AM - The AM antenna is located inside the cabinet of the unit. If AM reception is weak,
change the position of unit until the internal antenna picks up the strongest signal.
FM - To insure maximum FM tuner reception, unwrap and fully extend the FM antenna
wire for the best FM radio reception.
Radio Station Presets
The unit allows you to store up to 10 AM and 10 FM stations for easy recall at any time.
Setting Preset Stations
1. Tap the / FUNCTION button to turn on the unit.
2. Tap the / FUNCTION button to select AM or FM radio mode.
3. Tune to the radio station you want to store in memory by using the
/
buttons.
4. Press and hold the MEMORY button, the preset channel number appears on display
and blinks.
5. To select desired preset station number, tap the
/
buttons.
6. To confirm preset location, tap the MEMORY button.
7. Repeat steps 3 to 6 to store other stations if necessary.
Notes:
- There is an approximate 7 seconds delay when programming, after 7 seconds, the
unit will automatically switch back to normal tuner mode.
- You can overwrite a preset station by overwriting and storing the new frequency in
its place.