E-7
4.
If the unit is not going to be used for an extended period of time, please remove
the batteries. Using old, leaking or cheaply made batteries can cause damage to
the unit and may void the warranty.
5.
Do not dispose of batteries in fire, batteries may explode or leak.
6.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like.
7.
Replace all the batteries at the same time, no matter exhausted or not, every 2
years at the same time to avoid possible battery leakage.
8.
Do not try to recharge batteries not intended to be recharged; they can overheat,
rupture and leak. (Follow battery manufacturer's directions).
9.
Only an adult should replace the batteries.
STANDBY MODE
Standby Mode is when the unit is first plugged into an AC power source (display
flashing) or after all the settings have been made and the time is showing on the
display. Standby mode is also enabled when the Bluetooth/Radio/AUX are off, no
buttons are pressed and no alarms are sounding.
CLOCK SETTING
The LED DISPLAY (#11) will be flashing when the unit is plugged in for the first time.
The unit is now in
standby mode.
Setting the Time:
1.
In standby mode, press and hold the TIME SET
BUTTON
(#7)
until the hour digits of the clock display begin to
flash.
2. Repeatedly tap the SKIP BACKWARD
BUTTON (#5)
or SKIP FORWARD
BUTTON (#6) to set the hour.
Press and hold the buttons for fast advance/reverse setting. Make sure the correct
AM or PM time is selected when setting the hour.
Note:
The PM INDICATOR (#10) is located in the upper left part of the display.
The PM INDICATOR (#10) will light when the hour digits selected are for PM time.
The PM INDICATOR (#10) will be off when the hour digits selected are for AM time.
3.
Press the TIME SET
BUTTON (#7)
to confirm
the time and the minute digits will
flash
.
4.
Repeatedly
tap the SKIP BACKWARD
BUTTON (#5)
or SKIP FORWARD
BUTTON (#6) to set the minute.
Press and hold the buttons for fast reverse/advance
setting.
5.
Tap the TIME SET
BUTTON (#7)
to
confirm and complete the setting. The display
will stop
flash
ing.
Note:
The unit will automatically save the settings and exit the time set mode if you do not
press any buttons within 10 seconds.
