E-4
LOCATION OF CONTROLS
Controls and Functions of Unit
1. AM/FM Band Button
2.
/ Y-M-D / DST Button
3. Snooze / Sleep / Time Zone Button
4. Alarm Set Button
5. On / Off Button
6.
/ Temp / °C/ °F Button
7. Alarm 1 Radio / Alarm Button
8. Alarm 2 Radio / Alarm Button
9. Time Set Button
10. LED Display
11. Reset Button
12. Auto Off / High / Low Dimmer
Switch
13. AC Power Cord
14. Temperature Sensor (For indoor
use)
15. FM Wire Antenna
16. Infrared Sensor
17. Aux In Jack
18. Volume Knob
19. Tuning Knob
20. Speaker
21. Rating Label
22. Battery Door
23. Night Light
24. Light On/Off Button
POWER REQUIREMENTS
This unit operates on 120V~ 60Hz and requires 1 x CR2032 Lithium battery (included) for clock
backup during power outage. Prior to first use, please remove the plastic battery insulator tab to
activate the backup batteries. Do not attempt to operate the radio on any other power source. You
could cause damage to the unit and void your warranty.
REPLACING BACKUP BATTERY
1. Remove the screw from the BATTERY COMPARTMENT COVER and remove the
compartment.
2. Remove battery. Install 1 brand new CR2032 Lithium 3V battery according to the polarity
markings on the BATTERY COMPARTMENT COVER.
3. Replace the BATTERY COMPARTMENT COVER and tighten the screw to secure the
compartment.
NOTE:
The unit will operate without a battery installed, but your time and alarm settings will be lost
and will have to be reset in the event of a power interruption or failure.
IMPORTANT:
Be sure that the battery is installed correctly.
Wrong polarity may damage the unit and void the warranty.
For best performance and longer operating time, we recommend the use of good
quality batteries.
CAUTIONS
