GB - 6
CLOCK SETTING
ALARM SETTING
SETTING THE ALARMS
1. In standby mode, press and hold the ALARM
or
button for a few seconds until the LED
DISPLAY flashes.
2. Press
or
to select the wake up source: FM (FM frequency and indicator flash), AM (AM
frequency and indicator flash) or beep tone
.
Note: Be sure to observe the AM indicator when setting the alarm to make sure the alarm time is
set correctly for AM or PM. If the AM INDICATOR is ‘On’, the alarm time will be “AM”.
3. Press or
then press HR. and/or MIN. to set the alarm time.
Note: If you selected wake up to radio, the last radio setting will be used when the alarm time is
reached. Make sure the frequency and volume is set properly before putting the unit into
standby mode for next day alarm.
4. Press or
button to confirm, the ALARM INDICATOR
or
lights up steady.
5. To disable ALARM 1/2 from automatically sounding on the upcoming days, tap the
or
button, the corresponding ALARM INDICATOR
or
will go off.
6. To resume ALARM 1/2, tap the respective ALARM
or
button, the corresponding ALARM
INDICATOR or
will turn on and the alarm(s) will sound the next day at the set time.
TURNING OFF THE ALARM
When the pre-set alarm time is reached, the alarm or radio will sound for 60 minutes unless
interrupted by pressing SNOOZE. To stop the alarm immediately, tap the corresponding ALARM
or
button or POWER ON/STANDBY button.
1. In standby mode, press and hold the CLOCK button, the LED DISPLAY will flash to prompt for
input.
2. Tap the HR. button repeatedly to set the hour. Press and hold for fast forwarding.
3. Tap the MIN. button repeatedly to set the minute. Press and hold for fast forwarding.
4. Press the CLOCK button to confirm.
Notes:
• During the time set, if no buttons are pressed within 5 seconds, the current display time will be
automatically stored.
• Make sure the hour is set so that the AM indicator is displayed correctly for morning time.
POWER ON/STANDBY
1. In standby mode, press the POWER/STANDBY
button once to turn on the unit.
2. Press and hold
button for about 2 seconds to return the unit to standby mode.
