E-16
RESETTING
If the system does not respond or has erratic operation, you may have experienced an
electrostatic discharge (ESD) or a power surge that triggered the internal computer to shut down
automatically. If this occurs, unplug the AC cord from power source
,
wait for 60 seconds
,
then plug
the AC cord to power source again. The unit will be reset, you need to setup the clock, alarm and
preset radio channels.
CARE AND MAINTENANCE
1.
Do not subject the unit to excessive force, shock, dust or extreme temperature.
2.
Do not tamper the internal components of the unit.
3.
Clean your unit with a dry cloth. Solvent or detergent should never be used.
4.
Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5.
Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
6.
If drop-outs or interruptions occur in the music during CD play, or if
the CD fails to play at all, its bottom surface may require cleaning.
Before playing, wipe the disc from the center outwards with a good
soft cleaning cloth.
CLEANING THE UNIT
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts.
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinet.
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or
polishes as these will damage the finish of your unit.
CAUTION:
Never allow any water or other liquids to get inside the unit while cleaning.
TROUBLESHOOTING GUIDE
If you experience difficulties in the use of this music system, please check the following or
call 1-800-777-5331 for Customer Service.
Symptom
Possible Cause
Solution
The unit does not
respond (no power)
The unit is disconnected from the
AC outlet.
Reconnect to the AC outlet.
The AC outlet has not power.
Try the unit on another outlet.
Unit is ON but there is
low or no volume
Volume set too low.
Adjust the
VOLUME
control
knob on main unit or
on remote control to turn the
sound level up.
Bluetooth: no sound
Bluetooth speaker is not linked with
the cell phone
Go through the “Bluetooth
Operations” process to link the
speakers.
Speaker placement out of range
Relocate the speaker within
Bluetooth operating range
AM band is too noisy.
The reception for the station is weak.
Slightly rotate the unit for the best
reception.