Printed in U.S.A. Copyright © 2001, Jensen Transformers, Inc.
6
Figure 2.3 - Component Layout
either stranded or solid, may be used to make connections to the JT-MS-8N2.
Stranded wire
should be used if connections will be subjected to repeated movement or vibration, to prevent
breakage.
Under normal circumstances, the low side of the phantom power supply,
48C
, is connected
directly to the groundplane,
GND
, through the jumper at
P9
. If this needs to be changed for some
reason, the jumper may be moved to its alternate position, and the phantom power supply
common,
48C
on
J91
, may connected to some other reference point.
2.3 Input and Output Wiring
In order to avoid wiring confusion, the HI, LO and SHIELD connections are arranged in the same
order for each of the INPUT, THRU and OUTPUT connector positions.
2.3.1 Input Wiring
INPUT and THRU connections are provided on pins 1 through 6 of
J11
:
INPUT
HI, LO and Shield connections are on pins 1, 2 and 3 respectively.
THRU
HI, LO and Shield connections are on pins 4, 5 and 6 respectively.
2.3.2 Output Wiring
Isolated Output connections are provided on pins 1 through 3 of
J12
.
OUTPUT 1
HI, LO and Shield connections are on pins 1, 2 and 3 respectively.
Wire sizes between 14 and 26 gauge, either stranded or solid, may be used to make
connections to the JT-MS-8N2. Stranded wire should be used if connections will be subjected to
repeated movement or vibration, to prevent breakage.
