Mounting of Centre speaker:
This smart bracket
allows Centre Speaker to mount 3 separate ways:
Subwoofer amplifier features.
LED on front panel is
Blue
when active and
Red
when on standby (standby mode, like on a TV draws next to no power). Switch the Subwoofer
amplifier switch to
“AUTO”
and this can be left on indefinitely as the Subwoofer automatically
activates when it senses as incoming signal. LED’s will then turn
Blue.
After signal has been
removed between 15 and 40 minutes, amplifier will revert to Standby and LED will change to
Red.
•
Gain Knob
is your volume knob. This adjusts the output of your Subwoofer to balance
and harmonize with output of your 5 x Satellite speakers. DO NOT set this on maximum. Be
careful not to advance this control too far as overload may occur causing damage to your
Subwoofer speaker (see below setting recommendations).
•
Freq Knob.
This control adjusts how low (in frequency) you wish your Subwoofer to
operate at. In other words, 70 Hz is a lower and deeper frequency than 90Hz, so if you set at
70Hz you will be amplifying all music information
70Hz and below
and filtering out
everything above which is the ideal intention of a powered Subwoofer. Take care not to
advance this control too far as overloading may occur (see below recommendations).
•
Phase Switch
If you are using one Subwoofer in the room switch this to “NOR”. If you
are game, you can add as many JENSEN Subwoofers as you like within the room all daisy-
chained together. If more than one Subwoofer is used simultaneously, then all Subwoofers
need to be “in Phase” with each other so that “bass canceling” does not occur. If you do this,
connect all your subwoofers up and switch each from “NOR” (Normal) to “REV” (Reverse)
and simply leave on setting that provides the most Bass. This will be the best setting and be
correctly “in phase”.
•
Line Output sockets
are provided for stringing additional subwoofers using an
additional 1RCA to 1 RCA lead. As mentioned, you may “daisy-chain” as many JENSEN
subwoofers together as you like for massively increased Bass performance. Contact
[email protected] for more information on this.
Where should I set Gain & Freq. Control Knobs ??
Once you have your JENSEN X-125 Subwoofer positioned and connected, we suggest
experimenting with the Level Control knob and Frequency Control knob to suit the Volume and
1. Tabletop – aiming forward:
Peel away adhesive tape on the 25mm Rubber Blocks
(supplied) and by sitting bracket on it will result in
Speaker to aim forward. Conversely, by not using
Rubber blocks Speaker will aim upwards.
2. Wall mount – aiming downward:
By
wall mounting bracket horizontally and with long
“C curve” at Top will allow Speaker to aim downwards.
Screws supplied and screw spacing is
124.0
mm.
3. Wall mount –aiming forward:
By wall
mounting bracket horizontally and with short “C curve”
at Top will allow Speaker to aim level and forward.
Screws supplied and screw spacing is
124.0
mm.
Page 2.
