Your Elite-606
Is an integrated Active Subwoofer System with an 8” Heavy Duty
“Monster” driver powered by an on-board 140 Watt RMS amplifier. You may string additional
JENSEN Elite-606’s together if so desired by connecting to the “Line Output” section of your
JENSEN Elite-606 amplifier (see “For Big Bass Lovers” section below).
Elite-606
WD-140 amplifier module features.
GAIN:
(Volume knob). This adjusts the output of your JENSEN Elite-606 to balance and harmonize with
output from your Front / Center etc. etc. speakers. DO NOT set this on maximum. Be careful not too
advance this control too far as overload may occur causing damage to your JENSEN Elite-606 speaker (see
below setting recommendations).
FREQ:
(frequency knob).
This control adjusts how deep (low frequency) you wish your JENSEN Elite-
606 to operate at. In other words, 70 Hz is a lower and deeper frequency than 90Hz, so if you set at 70Hz
you will be amplifying all music information
70Hz and below
this frequency and filtering out everything
above which is the ideal intention of a Powered Subwoofer. Take care not to advance this control too far
as overloading may occur (see below recommendations).
ON/AUTO/OFF:
Blue
LED is ON and
RED
LED is standby (sleep). We recommend setting to
AUTO
which is a set-and-forget mode. Your JENSEN Elite-606 automatically activates when it senses as incoming
signal. After signal has been removed between 15 and 40 minutes, amplifier will revert to Standby mode
and LED will change to Red.
LOW LEVEL OUTPUT:
Are provided for adding additional JENSEN Elite-606 using an additional
1RCA to 1 RCA lead. You may add as many JENSEN Elite-606’s as you like (see
“For Big Bass Lovers”
below).
LOW LEVEL INPUT
:
Connect from your Multi Channel Receiver (5.1, 6.1 etc. etc) using RCA Cord
to this/these sockets. These are internally paralleled so connecting to one or both sockets makes no
difference. (See Option A below).
Phase Control Switch
is only used if several speaker boxes are in the one room (i.e. Center
Speaker, Surrounds etc.). This Phase switch can be set to ensure the Elite-606 woofer is “in phase” with all
other woofers operating together in the same room so that Bass cancellation does not occur. When your
entire speaker system is completely set-up, flick this switch from “NOR” to “REV” and leave on setting that
provides the most Bass. This will be the best setting and be correctly “in phase”. Leave switch on “NOR” if
no audible increase is detected.
HI-LEVEL IN / HI-LEVEL OUT
Only use these Red/Black Speaker Lead terminals if using a
STEREO amplifier. Simply, your JENSEN Elite-606 connects between your Stereo amplifier and Speakers. To
do this run pair Speaker Leads from Stereo amplifier into JENSEN Subwoofer
(Hi Level In)
then run a
second pair Speaker Leads from JENSEN Subwoofer
(Hi Level Out)
to Speakers. With this connection, full
frequency will always be delivered to Speakers so you are adding 140 Watts of Bass to your Speaker
System (see Option B below).