18
4.6
Functional Safety Parameterization in
WebMotion®
4.6.1
Display Active Safety Parameters
The defined Safety Functions and parameters are
shown in WebMotion® in the menu
application/io
.
This safety information can only be read, not
modified.
The parameters of the Safety Functions can be made
visible by pressing „Safety Param“.
Please refer to chapter 10 WebMotion® for further
explanations on WebMotion® interface.
If the XENAX® servo controller contains a Safety
Motion Unit (SMU) but no parameters are assigned,
the following message appears: “SMU not active, no
parameter se
t”.
The button directs to the page
where the parameters are set.
4.6.2
Modification of Safety Parameters
The safety parameters can be modified with
WebMotion
® and the functional safety login:
Enter IP address of the XENAX® servo controller and
add „/SAFETY.html“ in
Web browser.
E.g.
http://192.168.2.190/SAFETY.html
Password:
SafetyXvi75V8S
„OK“
Note:
Please pay attention to capital and small
letters.
