Jenn-Air UKF8001AXX, Use & Care Manual

Page: 7 / 96

6
Reinstallation of the Doors
1. Install hinge assemblies:
• Install top hinge loosely with 5
⁄
16
" hex head
screws.
• Install center hinge with Phillips screws.
• Freezer door models: Install bottom hinge with
3
⁄
8
" hex head screws.
2. Freezer door models: Insert bottom
hinge pin.
• Locate bottom hinge hole closest to
outside edge of cabinet, and insert
bottom hinge pin. Replace any door
shims, if present.
3. Freezer door models: Place hinge
side of freezer door on bottom hinge
pin and hold freezer door upright
while installing center hinge pin with
5
⁄
16
" hex head driver.
• Replace plastic sleeve.
• Replace any applicable door shims.
• Make sure the hinge pin is installed tightly.
4. Place hinge side of refrigerator
door on center hinge pin.
5. While holding refrigerator door
upright, tighten down top hinge
with
5
⁄
16
" hex head driver and
replace hinge cover.
Door Reversal
In some installations, reversing the door swing allows
for more convenient access to stored items. Both
doors can be reversed on freezer
door models and the
fresh food door is reversible on freezer drawer models.
1. Remove door(s) (see page 4).
2. Transfer cabinet plugs and cabinet
screws to opposite side of cabinet.
• Remove cabinet plugs with flat
blade of screwdriver tip wrapped
in masking tape.
• Remove center mullion screws
with 5
⁄
16
" hex head screwdriver.
• Freezer door models: Remove
bottom mullion screws with 3
⁄
8
" hex head driver.
3. Transfer door stops from bottom edge of fresh food
door and freezer door, if applicable, to opposite
side of door edge.
• Use a Phillips screwdriver
for removal and installation.
4. Install handles (see below).
5. Reinstall the door(s).
To avoid possible injury and damage to property:
• Place doors on a nonabrasive surface protected by
towels or rugs while working directly on doors.
CAUTION
Handles
Handle Removal
(style varies by model)
Materials Needed:
• 3
⁄
32
” allen wrench
To Remove:
• Remove set screw from
handle mounting post
using
3
⁄
32
” allen wrench.
• Repeat the procedure on
all posts to remove the
handle.
To Replace:
• Align handle with the mounting posts.
• Fully tighten all set screws to secure handle
in place.
I
NSTALLATION