leveling legs
4. Place the other two corner posts on the floor to the
side of the compactor. Grasp the sides of the com-
pactor cabinet and put compactor on its side on top of
the corner posts. Remove the shipping base from the
bottom of compactor.
3. Place two corner posts from carton on floor near
compactor. Open compactor drawer and remove any
shipping materials or other items shipped in the
drawer. Do not remove the compactor bag (if installed).
Grasp the handle and raise the front of drawer until it
clears the drawer stops. Grasp sides of drawer and lift
drawer out of compactor. Place the drawer on the two
corner posts.
Unpacking your compactor
NOTE:
• Do not grasp console to move compactor.
• Begin in the room where the compactor will be
located.
1. Remove compactor from shipping carton. Remove
all protective packaging materials such as tape and
shipping pads. Remove waxy residue caused by pro-
tective shipping material with a mild solution of liquid
household cleaner and water.
2. Check that power supply cord is attached to the cord
clip on the rear of the compactor.
cord
clip
Space requirements
Check the location where your compactor will be
installed. The cabinet opening should be square. You
should be able to fully open the compactor drawer. Six
inches (15.2 cm) of clearance is needed on the right side
of compactor drawer to be able to remove compactor
bag. Allow 23 inches (58.4 cm) in front of the compactor
to remove drawer.
34
1
⁄
8
"
(86.7 cm)
24"
(61 cm)
15"
(38.1 cm)
The overall look of your compactor may vary.
Product dimensions
Installing Your
Compactor
IMPORTANT:
Installer: Leave Use and Care Guide with the homeowner.
Homeowner: Keep Use and Care Guide for future refer-
ence and for local electrical inspector’s use, if required.
6
w
WARNING
Excessive Weight Hazard
Use two or more people to move and install
compactor.
Failure to do so can result in back or other
injury.
