background image

5

2. Drill a 

¹⁄₂

" (1.27 cm) deep hole in the bottom of the overlay 

panel for the bottom hinge pin as shown.

Bottom View 

Location Requirements

To ensure proper ventilation for your refrigerator, allow for a 

¹

/

(6.35 mm) space on each side and at the top. When installing 
your refrigerator next to a fixed wall, leave 2

¹⁄₂

" (6.35 cm) 

minimum clearance on the hinge side to allow for the door to 
swing open.

NOTE: It is recommended that you do not install the refrigerator 
near an oven, radiator, or other heat source. Do not install in a 
location where the temperature will fall below 55°F (13°C). For 
best performance, do not install the refrigerator behind a cabinet 
door or block the base grille.

Electrical Requirements

Before you move your refrigerator into its final location, it is 
important to make sure you have the proper electrical 
connection.

Recommended grounding method

A 115 Volt, 60 Hz., AC only 15– or 20–amp fused, grounded 
electrical supply is required. It is recommended that a separate 
circuit serving only your refrigerator be provided. Use an outlet 
that cannot be turned off by a switch. Do not use an 
extension cord.

NOTE: Before performing any type of installation, cleaning, or 
removing a light bulb, unplug refrigerator or disconnect power.

Unpack the Refrigerator

Remove the Packaging

Remove tape and glue residue from surfaces before turning 
on the refrigerator. Rub a small amount of liquid dish soap 
over the adhesive with your fingers. Wipe with warm water 
and dry.

Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your refrigerator. For 
more information, see “Refrigerator Safety.”

Dispose of/recycle all packaging materials.

A. Radius 5.0

¹⁄₂

"

(1.2 cm)

¹⁷⁄₃₂

"

(1.35 mm)

A

Back Surface

Front Surface

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as 
gasoline, away from refrigerator.

Failure to do so can result in death, explosion, or fire.

 

¹⁄₄

" (6.35 mm)

2

¹⁄₂

" (6.35 cm)

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, 
fire, or electrical shock.

WARNING

WARNING

Excessive Weight Hazard

Use two or more people to move and install 
refrigerator.

Failure to do so can result in back or other injury.

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator 
for cleaning or service, be sure to protect the floor. 
Always pull the refrigerator straight out when moving it. 
Do not wiggle or “walk” the refrigerator when trying to move 
it, as floor damage could occur.

Summary of Contents for JUR248RBES














Reviews: