18
Spill Tray Grille
Stainless Steel Splashguard
I N S TA L L AT I O N G U I D E – I N S TA L L I N G PA N E L S
O N D I S P E N S E R M O D E L S
Terminals
Control Panel
1. Power switch needs to be off. Switch
located in machine compartment area
(see User Guide).
2. Remove magnetic strip on door handle.
Use of tape may be required removing
the magnetic strip. (See FIG. 10a on
page 17)
3. Remove four Phillips screws to remove
door handle/trim. (See FIG. 10b on
page 17)
(Refer to numbered illustrations for steps 4-10)
4. Remove the spill tray grille from the
fountain.
5. Remove the two #15 Torx machine
screws, which retain the stainless steel
splashguard. Remove the splashguard.
6. Remove the two #15 Torx long plastic
screws that retain the fountain control
panel. (Longer screws). Slide control
panel down to remove. Disconnect the
electrical terminals going to the fountain
control panel. Tuck dispenser terminal
inside to avoid interference.
7. Remove the four #15 Torx plastic collar
screws from the fountain/escutcheon
collar.
8. Place the fountain/escutcheon collar
onto the backer panel. Use tape
to hold in place.
9. Open the freezer door and slide panel
onto the door.
10.The holes in the fountain/escutcheon
collar should line up with the mounting
holes in the door panel. Reverse instruc-
tions 7 to 1 (ex. Replace the four #15
Torx plastic collar screws from the
fountain escutcheon collar)
Freezer Dispenser Panel Installation
4
5
6
7
8
9
10
