3
INSTALLATION REQUIREMENTS
Tools and Parts
Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
■
Measuring tape
■
Pencil
■
Level
■
Masking tape
■
T20
®†
Torx
®†
screwdriver
■
Drill
■
1/16" (2 mm) drill bit
Parts Supplied
All of the following parts are provided, but some parts may not
be used. The location of your coffee system installation will
determine which parts you will use.
Location Requirements
IMPORTANT:
Observe all governing codes and ordinances.
■
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with coffee
system.
■
The built-in coffee system must be installed in cabinetry with
the dimensions provided.
■
Follow the installation instructions for any cabinetry used
to house the built-in coffee system. Make sure cabinet is
securely attached to the wall.
■
Follow the installation instructions.
■
Grounded electrical supply is required. See “Electrical
Requirements” section.
■
Refer to installation instructions for cutout dimensions for
any appliances installed above or below the built-in coffee
system.
IMPORTANT:
To avoid damage to your cabinets, check with
your builder or cabinet supplier to make sure that the materials
used will not discolor, delaminate or sustain other damage.
This coffee system has been designed in accordance with the
requirements of UL and CSA International and complies with the
maximum allowable wood cabinet temperature of 194°F (90°C).
Product Dimensions
B
C
D
E
F
A
A. Mounting brackets/runners (2)
B. Metal trim piece (1)
C. Bracket spacers (4)
(1 mm thick)
D. Power supply cord clip (1)
E.
3/16" x 5/8"
(
4.5 x 16 mm)
T20 screws (17)
F.
3/16" x 3/8"
(
4.2 x 9.5 mm)
T20 screws (2)
23⁷
/
₁₆
"
±
¹
/
₁₆
"
(59.5 ± 0.1 cm)
17⁷
/
₈
"
±
¹
/
₁₆
"
(
45
.4 ± 0.1 cm)
¹³
/
₁₆
"
±
¹
/
₁₆
"
(2.0 ± 0.1 cm)
18³
/
₁₆
"
±
¹
/
₁₆
"
(46.1 ±
0
.
1
cm)
16⁷
/
₈
"
(42.9 cm)
21⁷
/
₁₆
"
(54.5 cm)
1³
/
₁₆
"
(3.0 cm)
†
Torx and T20 are trademarks of Acument Intellectual Properties, LLC.
07-Mar-2019 02:29:19 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")