Jenn-Air JGRP536WP, Installation Instructions Manual

Page: 14 / 32

14
Check Operation of Cooktop Burners
Push in and turn each control knob to LITE.
NOTE: You will hear a clicking sound while the line clears.
The surface burners and grill flames should light within
4 seconds. The first time a burner is lit, it may take longer
than 4 seconds to light because of air in the gas line.
After verifying the proper burner operation, turn the control
knobs to OFF.
If burners do not light properly:
■
Turn cooktop control knob to OFF.
■
Check that the cooktop is plugged in and the circuit breaker
has not tripped or the fuse has not blown.
■
Check that the gas shut-off valves are set to the
open position.
■
Check that burner caps are properly positioned on
burner bases.
Repeat start-up. If a burner does not light at this point, contact
your dealer or authorized service company for assistance.
Flame Height
The cooktop flame should be a steady blue flame approximately
1/4" (6.4 mm) high.
Dual Flame Burner
Single Flame Burner
To Adjust Flame Height:
1.
Unplug range or disconnect power.
2.
Remove burner grates.
3. Remove the control knobs.
4. Open the oven door and remove the two screws on each
side of the range that hold the control console in place.
NOTE: Make sure to leave oven door open or the control
console will not rest in the side brackets properly once it
is detached.
5.
Pull up on the control console and let it drop forward into the
notched console brackets on each side.
6. Remove the round gasket from the valve stem.
7. Put a control knob onto the valve stem of the burner
you want to adjust.
8. Turn the control knob to LO and, using a butane extension
lighter, light the burner.
9. Remove the control knob.
10.
Use a 1/8" x 4
1
/
4
" (3 mm x 100 mm) flat-blade screwdriver to
adjust the flame height. Tighten screw to reduce flame
height. Loosen screw to increase flame height.
11. When finished adjusting the flame height, put a control knob
back onto the valve stem and turn off the burner.
12. Remove the control knob.
13. Replace the round gasket.
14. Repeat steps 6 through 13 for any other burners that
need adjustment.
A
B
A. Upper (simmer) flame
B. Lower flame
A
A. Control console bracket
A
B
A. Single flame burner adjustment screw (on right side of valve)
B. Dual flame burner adjustment screw (on left side of valve)