Installation
The EDENAIR FM-1 is portable and ready to plug in as it comes from the box. Its
effectiveness depends on the amount of ozone that is dispersed and allowed to contact the
ambient air.
Place the FM-1 as close to the offending agent as possible. The ozone concentration
is highest as it exits the unit.
Place the FM-1 as high in the room as possible. Ozone is heavier than air and will
drift down, neutralizing offending agents in its path.
Use existing air currents or larger circulating fans to help disperse the ozone. The
ozone will cover large areas as it travel on drafts or moving air, neutralizing odors
along its path.
OPERATION
Depress the ON button. When the machine is ON, the button glows red. A bleach like
odor is normal.
Maintenance
The EDENAIR FM-1 is relatively maintenance free.
Periodically clean the foam filter located on the left side of the unit, by removing and
washing it in warm soapy water. Air dry and reinstall. Clean the generator plate at the
beginning of each new season, or when you notice that the ozone production has
decreased.
Unplug the FM-1
( IMPORTANT)
Remove the screws that attach the output grill to the cover.
Remove the grill.
Carefully grasp the edges of the two ceramic generator plates and slide them out
toward you one at a time.
Wash in warm soapy water using a stiff non-metallic brush to scrub the wire mesh
clean. Air dry or use a hair dryer. Do not install wet plates as this will cause arcing
and damage the unit.
Next clean the contact area of the flat stainless steel springs with a Q tip moistened
with alcohol.
Reinstall by carefully sliding the ceramic plates back into the slot, making sure that
one of the two springs are making solid contact with each side of the plates.
Replace the grill and screws, and re-attach the power cord.
(Machine will not operate without these screws installed)