11
JREMO 10K
Industrial radio remote controller
CHAPTER 3. INSTALLATION & FUNCTION SETTING
3-2 HOW TO INSTALL
JREMO
® SERIES TX
3-2-1. BATTERIES
A. Insert 2 AA batteries at right position with + and -. An opposite position
will cause an excessive heat to cause battery leakage, burning, and so
on, any malfunction caused by such the poor batteries' handling will not
be of free recovery no matter how long the guarantee period remained.
B. Precautions
1. Do not use low power type rechargeable batteries.
Recommend : Use 2500mAH or above.
2. Use all new & fully charged batteries for replacement.
Any un-fully charged one(s) may cause the same to the above clause
3-2-1 A matters.
C. Change of Batteries : When led signals with red and green flashes in turn
it shows battery powers are low. Replace them all 2 batteries immediate-
ly and simultaneously with new ones.
D. When not in use press down the EMS button for saving battery life as
well as off the battery power, and for safety as well.
3-2-2. FUNCTION SETTING & COPYING
In case to change either Tx or Rx, or modify functions its mating transmitter
and receiver must be identical and set both at the same time for sure
identification. Function settings can be done either by the copier or by PC
software, or from direct Rx-Rf at Rx to/from Tx. Either method is an optional.
A. Function set by Copier
1. Unscrew Battery Cap at Tx and Open the top
cover at Rx.(Please note when the Copier to
use both Tx and Rx power should be shut
down.)
2. Connect Copier either to Tx or Rx.
3. Follow the instruction of Copier Manual
that will be provided as an optional order.
B. Function set by Software
1. Software can be provided as an optional order
and,
2. It needs another connector (i.e. Gender) with
Copier
Gender
