Jefferson Professional Tools & Equipment JEFWASPET075HP, User Manual

Page: 7 / 32

JEFWASPET075HP
7.5HP Petrol Pressure Washer
7
www.jeffersontools.com
Unpacking & Assembly
Specifications
Connecting the pressure hose to the pump
1. Pull back the high pressure outlet fitting collar. Insert the connector into
the quick release fitting and release the collar to close the fitting.
Carefully tug on the fitting to ensure it is secured.
Connecting the hose to the spray gun
1. Pull back the slip ring on the female quick connect fitting and
connect with the male outlet on the spray gun.
2. Release the slip ring on the female quick disconnect and twist. Listen
for a "click" to ensure that the coupling is secure.
Connecting the Lance to the Spray Gun
1. Remove the protective plastic cap on the lance connection.
2. Thread the lance connection onto the spray gun as shown
3. Tighten the nut to secure
Connecting the Nozzle / Removing the Nozzle
1. Insert the nozzle into the quick- connect fitting on the lance and press
to snap in the nozzle.
2. To remove pull back the slip ring to eject the nozzle. See page 8 for
more information about nozzle selection for various applications.
Connecting the pressure pump to the water supply
1. Connect the garden hose to the water supply and turn the water supply
on to run water through the hose and remove any debris prior to
connecting to the pressure washer,
then turn off the supply.
2. Check the filter inside the pressure washer inlet is clean and
undamaged. Thread the garden hose fitting into the water hose inlet. Hand
tighten to make a secure connection.
3. Turn on the water supply and check that there are no leaks. Ensure that
there is a minimum of 20psi and a flow rate of 5GPM.
Connections 5.
Preparing the pump for first use
This equipment is shipped with a special oil plug to prevent oil leak-
age from the pump during shipping.
You will need to replace the shipping plug with the breather plug pro-
vided before use. Hand tighten the breather plug to avoid damaging
the threads.