20
GETTING TO KNOW YOUR VEHICLE
Le présent appareil est conforme aux CNR
d`Innovation, Science and Economic Development
applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux
conditions suivantes:
1. l'appareil ne doit pas produire de
brouillage, et
2. l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. es posible que este equipo o dispositivo no
cause interferencia perjudicial y
2. este equipo o dispositivo debe aceptar
cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
This unit complies with ICES-003E of Innovation,
Science, and Economic Development (ISED)
Canada, and EMC Directive 2004/108/EC.
AC L
EVEL
2 C
HARGING
(240 V
OLT
,
40 A
MP
)
AC Level 2 (240 Volt) charging requires a 240 Volt,
Level 2 EVSE (Charging station). A 40 Amp Level 2
EVSE for home installation is recommended.
When using public charging stations, ensure the
charging station is ready to provide charge and the
vehicle is in PARK before the charge connector is
plugged into the vehicle’s charge inlet. You will
hear a “click” when the charge connector is
inserted correctly and is coupled with the vehicle’s
charge inlet.
NOTE:
The vehicle should start charging automatically.
If not, please check the following:
Charging Station — Check the indications and
instructions at the charging station.
Charging Schedule — Check whether the
charging schedule is enabled and if so, whether
the vehicle is currently within the scheduled
charge time/day (weekday/weekend). If the
charging schedule is enabled within the vehicle,
you may override it for this charging event by
plugging in the charge connector, unplugging it,
and then plugging it back into the vehicle charge
inlet. Complete the double plug sequence within
10 seconds for it to override the set schedule.
Hood Ajar — Check whether the hood is open.
Charging is disabled while the hood is open, and
will resume when the hood closes.
To stop the charging process:
Press the “STOP” button located on the front of
the EVSE station.
Remove the connector from the vehicle charge
inlet.
Plug the charge handle into the EVSE station
and coil the charging cord onto its holder. Do not
leave the charging cord lying on the ground.
C
HARGING
T
IMES
The following factors determine the time it takes to
charge the high voltage battery:
The high voltage battery’s current state of
charge
The type of EVSE used (Level 1 – 120 V or
Level 2 – 240 V)
Ambient temperature
Whether the vehicle’s ignition is in the RUN posi
-
tion during charging
22_JL_H_SU_EN_USC_t.book Page 20
