Auto Park Brake
The EPB can be programmed to be applied
automatically whenever the vehicle speed is
below 1.9 mph (3 km/h) and the automatic
transmission is placed in PARK, or with a
manual transmission, whenever the ignition is
in the OFF mode. Auto Park Brake is enabled
and disabled by customer selection through the
Customer Programmable Features section of
the Uconnect Settings.
Any single Auto Park Brake application can be
bypassed by pushing the EPB switch to the
release position while the transmission is
placed in PARK (automatic transmission) and
the ignition is in the RUN mode. In some cases,
like Automatic or Dual clutch transmission,
when the ignition is in the OFF mode EPB can
automatically apply even if it has been previ-
ously disabled
For further information and applicable warnings
and cautions, please refer to your Owner’s
Manual at www.jeep.com/en/owners/manuals.
Selec-Terrain
Selec-Terrain combines the capabilities of the
vehicle control systems, along with driver input,
to provide the best performance for all terrains.
Mode Selection Guide
Rotate the Selec-Terrain knob to select the
desired mode.
•
AUTO
: This four-wheel drive operation is a
continuous operation, is fully automatic and
can be used on and off road. This mode
balances traction to ensure maneuverability
and acceleration improvement compared to
a vehicle with two wheel drive. This mode
also reduces fuel consumption, since it al-
lows the disconnect of the drive shaft where
conditions permit.
Selec-Terrain Switch
Selec-Terrain Switch (Trailhawk)
