248
IN CASE OF EMERGENCY
P
REPARATIONS
F
OR
J
ACKING
1. Park the vehicle on a firm level surface as far
from the edge of the roadway as possible.
Avoid icy or slippery areas.
2. Turn on the Hazard Warning Flashers.
3. Apply the parking brake.
4. Place the ignition in the OFF position.
5. Block both the front and rear of the wheel
diagonally opposite the jacking position. For
example, if the driver’s front wheel is being
changed, block the passenger’s rear wheel.
Wheel Blocked
NOTE:
Passengers should not remain in the vehicle when
the vehicle is being lifted or raised.
J
ACK
L
OCATION
/S
PARE
T
IRE
S
TOWAGE
If equipped, the jack and tools are located in the
rear storage compartment, below the spare tire.
NOTE:
Items may vary depending on the trim level.
Jack And Tools Location
WARNING!
Do not attempt to change a tire on the side of
the vehicle close to moving traffic. Pull far
enough off the road to avoid being hit when
operating the jack or changing the wheel.
1 — Jack
2 — Alignment Pin
3 — Emergency Funnel
4 — Wheel Bolt Wrench
5 — Screwdriver
22_MP_OM_EN_USC_t.book Page 248
Summary of Contents for Compass 2022
Page 76: ...74 GETTING TO KNOW YOUR INSTRUMENT PANEL 22_MP_OM_EN_USC_t book Page 74...
Page 340: ......
Page 341: ......
Page 342: ......