NOTE:
•
A continuous chime will sound if the vehicle is driven
more than 1 mile (1.6 km) with either turn signal on.
•
Check for an inoperative outside light bulb if either
indicator flashes at a rapid rate.
White Indicator Lights
— Active Speed Limiter Ready Indicator Light —
If Equipped
This light will turn on when the Active Speed Limiter is on,
but not set.
/
— Adaptive Cruise Control (ACC) Ready
Light — If Equipped
This light will turn on when Adaptive Cruise Control
(ACC) has been turned on, but is not set. Refer to “Adap-
tive Cruise Control ” in “Starting And Operating” for
further information.
— Adaptive Cruise Control (ACC) Set Light —
If Equipped
This light will turn on when the vehicle equipped with
Adaptive Cruise Control (ACC) has reached the speed
desired and the set button has been selected. Refer to
“Adaptive Cruise Control” in “Starting And Operating” for
further information.
— Hill Descent Control (HDC) Indicator Light —
If Equipped
This indicator shows when the Hill Descent Control (HDC)
feature is turned on. The lamp will be on solid when HDC
is armed. HDC can only be armed when the transfer case is
in the “4WD LOW” position and the vehicle speed is less
then 30 mph (48 km/h). If these conditions are not met
while attempting to use the HDC feature, the HDC indi-
cator light will flash on/off.
— LaneSense Indicator Light — If Equipped
When the LaneSense system is ON, but not armed, the
LaneSense indicator light illuminates solid white. This
occurs when only left, right, or neither lane line has been
detected. If a single lane line is detected, the system is
ready to provide only visual warnings if an unintentional
lane departure occurs on the detected lane line.
Refer to “LaneSense — If Equipped
⬙
in “Starting And
Operating” for further information.
4
GETTING TO KNOW YOUR INSTRUMENT PANEL
155
Summary of Contents for Cherokee 2019
