Jeep 2014 Wrangler, Owner'S Manual

Page: 328 / 673

•
Personal Settings Not Avail. – Vehicle in Motion —
manual transmission
•
Door Ajar (with vehicle graphic showing which door is
open. A single chime sounds if the vehicle is in
motion).
•
Gate Ajar (with vehicle graphic showing the Liftgate/
back door open and A single chime )
•
Check Gascap (refer to “Adding Fuel” in “Starting
And Operating” for more details)
•
Oil Change Required (with a single chime)
•
ECO (Fuel Saver Indicator) — if equipped
Oil Change Required
Your vehicle is equipped with an engine oil change
indicator system. The “Oil Change Required” message
will flash in the EVIC display for approximately 10
seconds after a single chime has sounded to indicate the
next scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON position. To
turn off the message temporarily, press and release the
MENU button. To reset the oil change indicator system
(after performing the scheduled maintenance), perform
the following procedure:
1. Turn the ignition switch to the ON position. Do not
start the engine
.
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the LOCK position.
326 UNDERSTANDING YOUR INSTRUMENT PANEL