7. REMOTE CHIMA TERMINAL
When these terminals are shorted, the circuitry of four tone chime is activated. Also, you can use this terminal is for
remote control.
8. TELEPHONE IN TERMINAL
These terminals are to be connected to telephone exchange system for paginging. Use an Austel approved line isolation unit
with this input.
Note: When there are paging signal into this terminal, all other input signal except AMP IN is muted.
9. CH2~4 INPUT JACK
These jacks are for the CH2~4 input, input sensitivity and impedance is 3mV/600 ohm.
10. MUTE CONTROL
11. LINE/MIC SWITCH
When the other signal is muted by MIC1, CHIME and SIREN, this control is used for adjusting the muting level.
When using the MIC or LINE, please locate the input select switch to desirable direction.
12. PHONO/LINE JACK
This jack is for the input of turntable of magnetic cartridge and line, the signal is controlled by the volume phono/line.
13. PHONO/LINE SWITCH
When using the phono or line, please locate the input select switch to desirable direction.
14. PRE AMP OUT/AMP IN
This jack is for connecting the pre-amp out signal to external amplifier or a signal processor like equalizer.
15. GND TERMINAL
This is ground terminal to be connected with cahssis of the turntable to reduce hum to minimum. To further minimize hum,
it may be necessary to connect this terminal whth a wire to the nearest water pipe which goes directly to near ground.
16. SPEAKER TERMINAL
These terminals are for connecting the speakers. Select the terminals of 8 ohm, 4ohm or high impedance.
*Be sure not to make the total impedance less than rated impedance.
MODEL
JPA-1060
JPA-1120
82
Ω
70V
41
Ω
167
Ω
100V
83
Ω
VOLTAGE
R
EAR PANEL CONTROLS
7
