Current instructions at www.jeco-inc.com
1-800-893-3006
Page 2 of 3
To Assemble:
Step 1:
Carefully attach the pump (B) to the tube from the lighthouse (A), place the pump
(B) in the center bottom of basin (A).
Step 2:
Fill the plastic basin (A) with clean water, make sure the pump (B) is fully
submerged.
Note:
The maximum water level should be approximately 1.2 inches below the top edge
of the basin (A).
Step 3:
Finally, connect the plug of pump (B) to a GFCI outlet.
WARNING:
Always disconnect the pump (B) before placing your hands in the water.