Current instructions at www.jeco-inc.com
1-800-893-3006
Page 2 of 3
To Assemble:
Step 1:
Attach the
pre-assembled water hose to the pump (C), and then attach the LED
lights (B) to the light cable comes out from the pump (C), at last, place the pump in the
center of the bottom (A).
Step 2:
Fill the product (A) with clean water, making sure the pump (C) is fully
submerged.
Note:
The maximum water level should be approximately 1.2 inches below the top edge
of the basin (A).
Step 3:
Finally, connect the plug of pump (C) to a GFCI outlet.
WARNING:
Always disconnect the pump (C) before placing your hands in the water.