
Current instructions at www.jeco-inc.com
1-800-893-3006
Page 2 of 3
To Assemble:
Step 1:
Run the cord from the pump (D) through plastic tube at Large Basin (B), making
sure to place the pump in the center of Large Basin (B).
Step 2:
Carefully attach the Large Basin (B) to the Base (C), turning it clockwise until it
locks.
Step 3:
Connect the water hose to the pump, then carefully attach the first basin (A) to the
Large Basin (B), making sure to place the pump in the center of the Large Basin (B).
Step 4:
Fill the basin (B) with clean water, making sure the pump (D) is fully
submerged.
Note:
The maximum water level should be approximately 1.2 inches below the top edge
of the basin (B).