77/134
OPERATION
In order to prevent any handling mistakes, never fill the water and fuel tanks at the same time.
During filling, avoid handling contaminants near the fillers.
Open and close the filler caps with the suitable key.
Check the filler cap seals for condition during filling.
The tanks are fitted with overflow outlets and vents.
Never insert the water filling hose deep down into the system in order to prevent any over-pressure in
the systems.
REF
Designation
19
Water heater
21
Aft water tank
22
Filler of the aft water tank
23
Aft water tank vent
24
Forward water tank
25
Filler of the forward water tank
26
Forward water tank vent
28
Hoses for engine coolant
40
Reservoir valve 1
41
Reservoir valve 2
42
Valve (optional)
Forward water tank - 400 l
Aft water tank - 235 l
PIECE OF ADVICE - RECOMMENDATION
- Pay attention to the quality of the water for the filling up. Check if it is drinking water.
- It is possible to sterilize the tanks with a Clonazione tablet (sold at the Chemist's).
- If the boat is not used for long, purify the tanks and pipes with acetic acid (or white vinegar).
- For winter storage instructions and precautions, refer to Chapter 13.
WARNING
- Tanks nominal load capacity cannot be fully used based due to trim and boat
loading. A 20% reserve should be kept
8
WATER AND SEWAGE WATER
Summary of Contents for SUN ODYSSEY 44I
